Skip to main content

The Different Types of Inspections carried out by OSHA

The Different Types of Inspections carried out by OSHA
Usually, inspectors are sent out by OSHA to various work sites. There are many different reasons to this. OSHA compliance officers suspect potential danger, and then inspect. Through this inspection, OSHA can respond to the complaints put in by the workers, the accidents and fatal injuries. Regular inspections and visits are programmed by OSHA. This is done to catch hold of violations. Often there are chances of a re-inspection after the first inspection comes up with violations. OSHA 10 hour General Industry courses teach the types of inspections. The various kinds of inspections carried out by the OSHA inspectors are as listed below:

Imminent Danger: If an OSHA officer is absolutely certain that there exists a life threatening danger at the work site, they consult the employer and ask him to either eliminate the danger or evacuate all the employees from it. Here, the officer does not even wait for the regular OSHA procedures to be followed. If the employer refuses to comply, OSHA applies to the federal district court. If he complies, OSHA re-inspects the work sites after a number of allotted days.


Investigative: OSHA investigates those accidents that cause serious injuries and even death. The inspection should be carried out as soon as the injury causing hazard has been gotten rid off. Inspection is usually recommended by OSHA after one day. Inspectors interview all the employees, the supervisors, first responders and the law enforcement officers.


Employee Complaint: OSHA 10 hour General Industry courses say that any employee, who feels that their employer is violating the OSHA standards, can ask OSHA to perform an inspection. However, the inspection is not limited to only the complaint. Other areas too, that have not been mentioned in the complaint, may be inspected.


Programmed: Basic inspections are carried out by OSHA at hazardous work sites. These work sites are selected on the basis of the reported accidents, fatalities and dangers that are associated with the work carried out at that site.


Re-inspection: After the violations are found at an industrial facility, the employer is notified of it by OSHA. Also, he is allowed an adequate period of time to correct the cited problems. The employer has all the rights to challenge the violations. At this, OSHA responds by taking into consideration the point of view of the employer. It might also make the appropriate arrangements with the employer. If the citation is upheld, a follow up inspection is carried out to see if the violations have been put right.
For further information, visit: http://www.osha10hourtrainingcourses.com

Comments